Detail PS-200 Dual TDS Controller
Install the Dual TDS Controller to constantly monitor TDS levels of water produced by a high-output system. Immediately know if the TDS levels rise above an acceptable level.
FEATURES
• Monitors and controls TDS levels of two water lines ( e.g., feed water and product water) for high output commercial systems.
• Large, bright L.E.D. display.
• An alarm will sound if the TDS level rises above the user-set level for the output water.
• Installs easily in minutes.
• Includes two sensor probes ( at no extra cost) .
• The PS-200 is a monitor for Line 1 ( in-line) and a controller for Line 2 ( out-line) .
• Protective cover also available ( sold separately)
SPECIFICATIONS
Range: 0 - 999ppm
Accuracy: ± 2%
Conversion Factor: NaCl ( avg. 0.5)
Resolution: 1PPM
ATC: Yes ( 1 - 65 degrees Celsius)
Calibration: Adjustable
Setting: Controlled by on-screen up/ down buttons
Relay Control: The unit will open or close a circuit via dry contacts when the ppm level ( out line/ line 2 only) reaches or exceeds the control setting ( simple switch) . It can be used to control a pump, solenoid valve or other device. ( In line/ Line 1 does not have a control function)
Relay Voltage: 5V ( simple switch)
Alarm: Optional steady beep for Out line/ Line 2 ( set by user)
Display: Bright 5/ 8" L.E.D. display
2 Probes: 1/ 2" bushing, 3 meter ( 9.8 ft) shielded cable
Power supply: AC 110V / AC 220V
Dimensions: 7.2 x 7.2 x 10.2 cm ( 2.8 x 2.8 x 4 in.)
Monitor Weight: 476 g ( 1 lb .8 oz)
Total Weight: 822.1 g ( 1 lb 13 oz)
Tampilkan Lebih Banyak